Couple of minor issues coming to light already with my paint job. Some petrol leaked out of the filler when I had the car over on its side a bit with a full tank. Over quite a bit really. I rinsed pretty thoroughly with water but where I had stone guard under the acrylic came off. This was the bottom of the rear quarter under the fuel cap. Now the isn't around the cap is showing some shrinkage cracks perhaps from the same cause. No tiller there i font think.
The other issue is at the lap join i did on the lower rear passenger guard patch. There is a crack in the paint on the join line. Should have butt welded it but was persuaded to lap it in the interests of keeping the guard straight.
Sent from my SM-G973F using Tapatalk
getting my FB ute on the road
EK van on rotisserie
Clay, its the combination of fuel chemicals and the lack of quality in todays automotive paints.
As the repair industry leans toward 2 pack the paint manufactures don't bother supporting the acrylic market like they once did hence the quality is a reflection of this.
Funny enough when unleaded fuel goes off it stinks and smells a lot like varnish so I often wonder what chemicals are in it ?
I don't know what it is but you can get thinners to melt modern acrylics very quickly but on the older panels the paint seems to be tougher and more difficult to remove.
What brand was the stone guard just as a matter of interest ?
Took Raff for a lesson down the back roads. He found the throttle a little touchy and the steering a little vague but didn't seem to worry him too much. Stalled on the ramp at Sellicks and had to do a tricky hill start with the dodgy handbrake. Crossing main south road on a busy Sunday morning was another challenge well met.
Sent from my SM-G973F using Tapatalk
getting my FB ute on the road
EK van on rotisserie
Nice day out Clay.
Raff’s a lucky fella learning to drive in one of these. Not many kids have heard of “three on the tree” let alone driven one. He’ll be able to drive anything after this.
Cheers, John
He’ll learn to leave space, brake early, watch the road ahead and that gears are just as important as the loud pedal. Great education.
The indents in the glovebox door make awesome cup holders. I had dreams of embedding some deeper ones into the wagon (to hold a drink whilst moving) but the concept got lost in the body repairs.
Cheers,
Harv
327 Chev EK wagon, original EK ute for Number 1 Daughter, an FB sedan meth monster project and a BB/MD grey motored FED.
EK283 wrote:Clay, its the combination of fuel chemicals and the lack of quality in todays automotive paints.
As the repair industry leans toward 2 pack the paint manufactures don't bother supporting the acrylic market like they once did hence the quality is a reflection of this.
Funny enough when unleaded fuel goes off it stinks and smells a lot like varnish so I often wonder what chemicals are in it ?
I don't know what it is but you can get thinners to melt modern acrylics very quickly but on the older panels the paint seems to be tougher and more difficult to remove.
What brand was the stone guard just as a matter of interest ?
Greg
Can't remember sorry Greg
Sent from my SM-G973F using Tapatalk
getting my FB ute on the road
EK van on rotisserie
59wagon wrote:Nice day out Clay.
Raff’s a lucky fella learning to drive in one of these. Not many kids have heard of “three on the tree” let alone driven one. He’ll be able to drive anything after this.
Cheers, John
Sent from my iPhone using Tapatalk
Yes he's getting some variety John.
He spun the rears or one of them at least on the ramp at Sellicks with a car behind waiting. Eldred would have smiled no doubt.
Sent from my SM-G973F using Tapatalk
getting my FB ute on the road
EK van on rotisserie