fbekholden.com

Nice one Gaz,

Small journal steel crank ? very hard to find with a virgin bore.

These old oilers go very hard if the combo's right, light wieght EK Ute even better !

Regards Greg

Gotta love a Chebby .

Cheers,
Harv

In the Shed wrote:Hey Gaz,
That donk should get the ute moving along nicely. What size is your touch up gun?

Stephen

Touch up gun is a 1.2 ANI



Sent from my iPad using Tapatalk

EK283 wrote:Nice one Gaz,

Small journal steel crank ? very hard to find with a virgin bore.

These old oilers go very hard if the combo's right, light wieght EK Ute even better !

Regards Greg

Thanks Greg, took you advice and read Smokey’s book now to wait and see how the little Mighty Mouse turns out


Sent from my iPad using Tapatalk

Little upgrade for small block




Sent from my iPhone using Tapatalk

WesternWagon wrote: Thu Oct 18, 2018 9:22 pmLittle upgrade for small block

Cool... that'll get it breathing .

Cheers,
Harv

One is no good Gaz, you need another one for the other side.

Bugga I knew there was something missing


Sent from my iPhone using Tapatalk

Good to see you back at it mate when did you get back?

Neil

FireKraka wrote:Good to see you back at it mate when did you get back?

Neil

Got back Tuesday arvo
Been finishing the shed and lean to
Hope to get stuck into the ute next week and get the seatbelts in






Sent from my iPhone using Tapatalk

Looking great mate that's going to give you plenty of room.

Neil

Pulled the covers off the 202 today, fresh build 5 years ago
Would get the ute going a lot quicker have a rebuilt trimatic and high stall too










Sent from my iPhone using Tapatalk

gets my vote gazza


Sent from my iPhone using Tapatalk

Steering wheel getting some attention

Going to try 2k urethane with epoxy primer












Sent from my iPhone using Tapatalk

Bit of Bumper primer then a quick sand and some 2k
Good as new




Sent from my iPhone using Tapatalk