Re: Dave’s EK supercharged v6
Posted: Mon May 17, 2021 8:56 am
Vy commodore
fbekholden.com
FB-EK Holden Car Clubs of Australia
https://fbekholden.com/forum/
Dave’s EK supercharged v6
Page 2 of 8
Re: Dave’s EK supercharged v6
Posted: Mon Jun 28, 2021 7:54 pm
Got some new tooling to help with some fabrication
Re: Dave’s EK supercharged v6
Posted: Mon Jun 28, 2021 8:44 pm
Look forward to seeing what you make with this!
Re: Dave’s EK supercharged v6
Posted: Mon Jun 28, 2021 9:47 pm
Just putting some money aside for my shrinker stretcher and I should be right to go
Re: Dave’s EK supercharged v6
Posted: Tue Jul 20, 2021 10:11 pm
Getting ready to high fill the firewall
Re: Dave’s EK supercharged v6
Posted: Tue Jul 20, 2021 10:30 pm
I hope it’s warmer in your shed than it is in mine Dave. Shivering in lockdown in SA. Do I recognise Epotec green grey etch prime?
FB ute fixer upper, EK van on rotisserie
FB ute fixer upper, EK van on rotisserie
Re: Dave’s EK supercharged v6
Posted: Tue Jul 20, 2021 11:35 pm
Yeh I always spray bare metal in that before anything I do
Re: Dave’s EK supercharged v6
Posted: Wed Jul 21, 2021 6:26 am
It’s very cold here too but if you close everything up and get working it isn’t too bad. Probably still a lot warmer then where u r haha
Re: Dave’s EK supercharged v6
Posted: Thu Jul 22, 2021 9:09 pm
All in high fill now
Re: Dave’s EK supercharged v6
Posted: Thu Jul 22, 2021 9:12 pm
Here
Re: Dave’s EK supercharged v6
Posted: Thu Jul 22, 2021 9:14 pm
What are u doing with Pedals Dave. Do u need to swap to a commodore or are you changing boosters. Just looking at the firewall. Nice to see some action. 
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Re: Dave’s EK supercharged v6
Posted: Thu Jul 22, 2021 9:16 pm
Commodore pedals easier to patch everything and drill what is needed and patch once I get to it there was holes everywhere
Re: Dave’s EK supercharged v6
Posted: Thu Jul 22, 2021 9:28 pm
I meant the guy before me butchered the firewall if I weld up most holes and then start again and patch paint as I go.
Re: Dave’s EK supercharged v6
Posted: Fri Jul 23, 2021 9:05 am
Nice Dave. What product and thinner ratio are you using?
FB ute fixer upper, EK van on rotisserie
FB ute fixer upper, EK van on rotisserie
Re: Dave’s EK supercharged v6
Posted: Fri Jul 23, 2021 9:12 pm
Using 4:1 but with about 20% thinner