Page 2 of 2
Posted: Sun Aug 14, 2016 6:22 pm
by Shain Mullavey
Been a busy the last month haven't had any time for the poor old girl. So today I made some time and finished striping the rear passengers side quarter. Can I just say the last person that did the body work on the ute spent more money on bog then they would have buying a gold plated set of hammers and dollies.
Re: FB ute V6 project
Posted: Mon Aug 29, 2016 8:32 am
by nes138
Hi Shain, are you transplanting the whole wiring harness or using an adapter harness? I did the VT system and have all the info if needed. I'm rarely on this forum but a regular on the FC forum.
I used all the wiring from VT and now have power windows Cruise control Boot release Central locking etc etc.
Looks like your going to be doing a lot of panel work before you start the conversion!
Sent from my iPhone using Tapatalk
Posted: Wed Sep 21, 2016 3:59 pm
by Shain Mullavey
Yes I am thinking of using the by wiring harness.
Have been busy at work so not much on the ute. Got some more paint striped off and found more doggy work.