fbekholden.com

Thanks Clay. Thought so, but needed to be sure.

and will need spigot bush ...............

I noted your post about spigots Blacky. Also how you used the bolt and grease to get it out.

Sent you a pm Clay but it bounced cause your box is full or something technical.

Brett027 wrote: Mon Feb 08, 2021 7:29 pm I noted your post about spigots Blacky. Also how you used the bolt and grease to get it out.

I use wet newspaper to get them out mate, way less mess than grease ........

Brett027 wrote:Sent you a pm Clay but it bounced cause your box is full or something technical.

Deleted a few messages Brett so try again if you like


FB ute fixer upper, EK van on rotisserie

Didnt know about wet newspaper- how does that work?

Sent from my SM-G975F using Tapatalk

Just tried again Clay and it bounced again and says you are over quota. I'll try tomorrow

Deleted a whole lot more


FB ute fixer upper, EK van on rotisserie

Brett027 wrote: Mon Feb 08, 2021 8:17 pm Didnt know about wet newspaper- how does that work?

Sent from my SM-G975F using Tapatalk

Exactly the same as grease , also heard of people using bread - never tried that because it sounds stupid to me , you just need something that is incompressible and malleable I guess. The wet newspaper works well and i just leave it to dry and its easy to dig out and clean up

Gathering bits together. HR front and back brakes and axle and steering stuff, collapsible column and a few other goodies.

Sent from my SM-G975F using Tapatalk

Brett,

The HR front suspension has LC-J Torana discs and calipers fitted to it. But it probably won't make any difference from a user's point of view.

Rob

Thanks Rob, I wasn't sure, so good to know. I wish you visited more often

Brett027 wrote: Mon Feb 15, 2021 2:48 pm Gathering bits together. HR front and back brakes and axle and steering stuff, collapsible column and a few other goodies.

Sent from my SM-G975F using Tapatalk

Brett
Utes come in handy for storing junk, that is until you want to drive it and you have unload them first
Stephen

Just a bit of forward planning while waiting for paint to dry...
What are people using for the reinforcement panel inside ute sills? I have some to do.