fbekholden.com

Got the struts on.
They may be too strong.


Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Rare Spares tailgate mechanism needs a frame to bolt to.


Sent from my iPhone using Tapatalk

don't fade away Trev great seeing something different cool and interesting being built and in a timely manner again (that is unless you lose interest again )

Progressing well. Glad to see you found a lock mechanism. Looking forward to seeing this one finished.

I’m getting reminded on Facebook that 5 years ago today I was working on the same tailgate.
I’m pretty motivated at the moment.
I hope it lasts too.


Sent from my iPhone using Tapatalk

Looking good! Keep up the momentum Trev.


Sent from my iPhone using Tapatalk

Errol62 wrote:Looking good! Keep up the momentum Trev.


Sent from my iPhone using Tapatalk

If only this was my only car that needs attention.
Today I’m putting the auto back in my Valiant. Shouldn’t take too long but it’s time I could be spending on the FB.


Sent from my iPhone using Tapatalk

Great engineering skills there. Perhaps the weight of the glass will alter the tailgate struts a bit. Regards Daz.

EK DAZ wrote:Great engineering skills there. Perhaps the weight of the glass will alter the tailgate struts a bit. Regards Daz.

“Skills” that might be stretching it a bit.
These struts are 600nm so they’ll take all I can give.


Sent from my iPhone using Tapatalk

Threw on the front guards and bonnet to get the radiator support brace the correct length.


Sent from my iPhone using Tapatalk

Looks good Trev


Sent from my iPhone using Tapatalk

It does revitalise the interest when you do that i must admit.

Keep going Trev, looking good.

Greg

Radiator support done.


Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk