fbekholden.com

nah mate didnt bend it. i ordered it off the net and they gave me an eh one which has that kink in it. just had to put shorter rods on it to make it fit.

Nice bay

thanks scoobb

Whoops!

that doesn't look good. did it make much noise?

Ouch!

Yeh got real noisy, turned it off straight away thought it was a head gasket. has since been replaced and runs again but will be upgraded.
dad got the webers on today whilst i was at work. just needs the radiator fixed then a tune.

So we worked pretty hard last week and got it running. the redline lincagge kit was junk the lynx manifold even worse. but is sorted now and sounds pretty tough. just finishing touches now and some more fiddling around with the carbies to do.

Looks sweet as mate , you should bring it on the Pipeline cruise so I can have a look

Looks fantastic

Sweet

Very nice rig mate.

Havn't shared much in a while. Thought I would share a quick video of my cam and a pic of the new radiator.
Snapped and bent the studs in the head recently so its out of action for a while and has been replaced with the old motor to get around in. Also found out that the jets and chokes in the carbies I bought for the 202, which where recommended are all wrong. So I need to buy the correct ones which isn't going to be cheap. but that's once I can find someone who really knows there webers. which is becoming difficult. So all in all, troubles but hopefully finish it soon.

If your after somebody that's good with Webbers I'd go looking at a workshop that specialises in Italian vehicles I did years ago and they sorted my problems

ok. yeh ive talked to a lot of people that all have different ideas. cheers