Front Swaybar with hr front end

[FATBOY]

Which one do i get the one on the ute hits the out rigger is there any tips
regards fatboy

[Sammy]

from what i can recall there are two different ones, one has a section that goes forward (towards the radiator) around the harmonic balancer and then theres one that goes down in the same area ... i thnk the down one will hit your outrigger but the forward one wont.

[FATBOY]

the one on the ute is hitting on the outrigger can i buy a swat bar that wont hit eg hr or ek ???

regards fatboy

[Sammy]

can you get a picture of the one thats on there now ? is it the one that goes forward or down in front of the engine ?

[FB MAD]

I've got a big K Mac swaybar on mine that was on the car when I bought it.

It's near enough to an 1 inch or so thick and points to the front of car just above the outrigger and near the harmonic balancer.

When I lowered the front ( about 3 inch ) I found it was knocking against the outrigger at times.

To remedy the problem, I cut, shortened and reweld the "swaybar to lower control arm links" by about 2 inches or thereabouts.

That gave the sway bar "pointed bit" a different angle near the outrigger and stopped it from hitting/rubbing on the outrigger.

Hope that info helps,

[FATBOY]

mines hitting on the outrigger looks to be a standard bar
regards fat

[ben]

Pritty sure i used the orig FB bar, looks like this anyway

[FATBOY]

Mine has a kick up over the outrigger but not enough
regards fatboy

[Sammy]

when the car is sitting on the ground is the swaybar sections that go backwards are they parallel to the ground ?

if its not that then it may just be that you have the wrong bar ?