LS1EK

[TAZ]

Just a few random shots. Only the front suspension to come out but I need to drill
the locating holes for the steering shaft grub screws before I remove it.

[Blacky]

coming apart for paint mate ????

[FireKraka]

Is there no front sway bar Taz???

[TAZ]

coming apart for paint mate ????

Yes mate, underside, engine bar and all front and rear suspension etc.

[TAZ]

coming apart for paint mate ????

Yes mate, underside, engine bar and all front and rear suspension etc.

[TAZ]

Is there no front sway bar Taz???

Is on my list to look into, shoot me a suggestion if you have one for incorporating one into the front end.

[Blacky]

What about something like this mate ?

https://www.ebay.com.au/itm/27666496683 ... QMQAvD_BwE

[Harv]

Just a few random shots. Only the front suspension to come out but I need to drill
the locating holes for the steering shaft grub screws before I remove it.

Those headers look mean and purposeful

Cheers,
Harv

[FireKraka]

I just looked at the link Blacky I would assume with the front mounted rack the kit would be the best way to install a sway bar.

I just had a look at the CRS independent front end and they say you must use a HR Sway Bar, the photo looks like they have 2 posts that the sway bar would fit onto.

[TAZ]

So I have a sway bar sitting in the shed for the front suspension. Thanks for the input gents. I just need to fabricate some mounts to set it up.

Engine almost ready to head to the machine shop. Will be looking to increase the engine from 5.3 to 5.7, just do not tell the engineer.

Underside more or less sorted , I just need a couple of days to strip it and hit it with some primer.