Gimme 5 years

[62ekute]

Hi Brett, it's part of the floor shift (similar to this pic from Harv's document). Patrick

IMG_20210402_140129.jpg (67.15 KiB) Viewed 601 times

[Brett027]

A Speco? Thanks Pat.

[Brett027]

A Speco? Thanks Pat.

[gpi]

what other type is there?

[62ekute]

A Speco? Thanks Pat.

looks a lot like a Dor (except the angle may have been replaced) or the whole thing could be a bitsa

IMG_20210402_152021.jpg (53.19 KiB) Viewed 589 times

Patrick

[gpi]

could be worth $1500

[62ekute]

could be worth $1500

nah, it's not original - I replaced the gear knob for this one with instructions

gear knob.jpg (31.29 KiB) Viewed 572 times

[62ekute]

I didn't get any EK stuff done over the Easter break, but got out there today and took the driveshaft off.

Grabbed the press off the shed floor and put it on a bench in the garage (I need more room so I can have all my toys out at once)

unis 2.jpg (84.19 KiB) Viewed 549 times

I've got a couple of new universal joints but decided today I'll also get a new slip yoke - few too many grooves and scratches on the existing one (don't show up in the pic but there was some oil getting through past the seal)

Patrick

[Errol62]

I know what you mean about the space. All these tools take up much space.

FB ute driver, EK van project

[62ekute]

Been down the coast for a bit - got back today (noticeable temperature drop coming back into town - not looking good for tinkering with cars)

Some of my recent purchases were here ... slip yoke; and shoulder bolts and wave washers for the floor shift

slip yoke.jpg (88.63 KiB) Viewed 506 times

Patrick

[Brett027]

Mornings are a bit chilly here now Patrick. Had the fire on at night now for a week. I used heat lamps today trying to get stainless strips back in front window rubber. Great you had a break on the coast.

[62ekute]

Hi Brett - yep, can't see much happening outside before lunchtime. Patrick

IMG_20210418_182833.jpg (27.13 KiB) Viewed 495 times

[FJWALLY]

I ordered the clutch kit from Automotive Superstore because they came up a fair bit cheaper (and I had a voucher from them as well)

...it turned up today in a sealed Exedy box with all the bits

clutch 2.jpg

clutch 4.jpg

Patrick

Is that the standard 200mm one Patrick? Happy with the quality? I might try the heavy duty one for the ute


Sent from my iPhone using Tapatalk Pro

[62ekute]

yep, just a standard 200mm clutch - should be okay for a standard grey and crashbox - exedy seems to be a good/popular brand

[Blacky]

Hi Brett - yep, can't see much happening outside before lunchtime. Patrick
IMG_20210418_182833.jpg

Ye Gods - already ? We just left the pub and I said to the Mrs "it's getting cold" - just checked , its 18 degrees going to get down to 11 tonight , winter is on its way .......