Gimme 5 years

[Errol62]

I am impressed with your progress. How is the a pillar bottom?


FB ute fixer upper, EK van on rotisserie

[62ekute]

There's enough of the pillar/sill-end there to anchor everything off, but yeah, there'll be some new metal going in.

[Blacky]

Theres a mob named Stark industries makes nice A pillar inner and outer lowers that make life lots easier

[62ekute]

yeah nice, I saw them advertised on kingswoodcountry's website - can't really justify it on this one - bit of patching will fix it

https://www.kingswoodcountry.com.au/buy ... kFB-EK-A-z

[62ekute]

put in one of these

RP20.jpg (1.82 KiB) Viewed 574 times

and one of these

FC-SFM-R.jpg (5.15 KiB) Viewed 574 times

x (2).jpg (124.82 KiB) Viewed 574 times

[Errol62]

Thosenumber one body member bits are easy to fold up in the vice with 18# sheet

Sent from my SM-G973F using Tapatalk

[62ekute]

yeah, I've got a manual sheet-metal bender which is pretty handy for making patches ... but, it was so easy (lazy) to go through all of the available repair sections and buy them in one go

s.jpg (20.55 KiB) Viewed 563 times

[Errol62]

Very handy machine. What length can you bend?

Sent from my SM-G973F using Tapatalk

[62ekute]

It's 750mm wide. I picked it up from Supercheap a while back for about $50

It's advertised as being able to bend up to 1.4mm thick. One of the reviews says it struggles with anything over 1mm and 500mm in length.

I usually work with 1.2mm and haven't had a problem. I clamp the top plate down with a couple of pairs of vice grips.

[Errol62]

Sent from my SM-G973F using Tapatalk

[EK283]

yeah nice, I saw them advertised on kingswoodcountry's website - can't really justify it on this one - bit of patching will fix it

https://www.kingswoodcountry.com.au/buy ... kFB-EK-A-z

Yeah would have been good to have something like that when I replaced mine, had to guess and make it by hand !

Good progress on the ute !!

Greg

[FireKraka]

I have the same little bender it works pretty well but as you say just have to clamp the centre, I just use a couple of G clamps.
Neil

[Errol62]

I thought about getying one but for the inner sills needed 1.6 and that is expensive so thought why bother and folded up in the vice. But now you can get them stamped with the circle indents might have to rip them off and go again.

Sent from my SM-G973F using Tapatalk

[62ekute]

I thought about getying one but for the inner sills needed 1.6 and that is expensive so thought why bother and folded up in the vice. But now you can get them stamped with the circle indents might have to rip them off and go again.

Sent from my SM-G973F using Tapatalk

yeah, I saw those stamped sills for $480 a pair - but considering that I'm not 'restoring' the EK, I went with the flat steel for a quarter of the price (and I think once they're in there's not a lot of chance I'll 'rip them off and go again')

[Errol62]

That I what I thought when I put them in my van. Was s lot of work bending them up from scratch in 18#.

Sent from my SM-G973F using Tapatalk