LS1EK

[Errol62]

Sent from my iPhone using Tapatalk

[TAZ]

160 amp alternator finally arrived from the states. It has a slightly different rear configuration including being slightly smaller which means it has more clearance. Now i need to sort a radiator, i have the one from the statesman but the bottom hose outlet and trans line pipes are placed out where the inner guards are so will require me to cut the panels to route the hoses and pipes.

Sent from my LG-K500 using Tapatalk

[TAZ]

Desert Cool radiator being made to fit 600x450 with twin 12" thermo fans. That should keep things cool

Sent from my LG-K500 using Tapatalk

[Blacky]

sweet

[TAZ]

Glad to finally be welding some steel in.

Sent from my LG-K500 using Tapatalk

[TAZ]

Glad to finally be welding some steel in.

Sent from my LG-K500 using Tapatalk

Finished the night of by welding in the new fire wall and fitting and then also welding the drivers side lower footwell.

Sent from my LG-K500 using Tapatalk

[FireKraka]

It's great when you see progress Taz and keep posting photos mate I really take my hat off to your skills there the flat floor is looking great.
Regards
FireKraka

[Errol62]

Great work Taz. What gauge you using for the floor?
Cheers
Clay


Sent from my iPad using Tapatalk

[TAZ]

1.2mm zincseal, could possibly go thinner though but then you get the chance of more distortion.

Sent from my LG-K500 using Tapatalk

[Errol62]

Sent from my iPad using Tapatalk

[TAZ]

Well a bit more done tonight, collapsible steering column bracket fabricated and mounted installed. Now need to holesaw a hole into the floor and fabricate up a floor mount.

Sent from my LG-K500 using Tapatalk

[EK283]

Hi Mr Taz,

You are doing an awesome job and progressing quickly.

Just remember your steering wheel must collapse toward the firewall, slide off the tabs toward the engine.

Mate you certainly have the fabrication skills well done.

Regards Greg

[TAZ]

Hi Mr Taz,

You are doing an awesome job and progressing quickly.

Just remember your steering wheel must collapse toward the firewall, slide off the tabs toward the engine.

Mate you certainly have the fabrication skills well done.

Regards Greg

Ha i wondered if anyone would pick that up l realised that i had it arse about face, could not be bothered changing it around at 10.30 last night

Sent from my LG-K500 using Tapatalk

[searay]

Really nice build love the pictures. I am about to start doing the same build, just waiting for my motor to arrive from the states. I might go a rodtech front end

[searay]

Really nice build love the pictures. I am about to start doing the same build, just waiting for my motor to arrive from the states. I might go a rodtech front end. Have you change one of the front end out riggers to RHS. Its hard to tell but have you made the subframe all one piece to the frame?