My Chopped wagon

[Trev]

Looking good Trev, can I suggest ditching the overrides to see how it looks?

Yes they do dictate how far back the bumper goes.

[Trev]

im not a fan of the stands trev

Geez, they are NASCO Paul!

[EK283]

Trev,

If you ditch the overiders I will buy them off you

Regards Greg

[Trev]

Trev,

If you ditch the overiders I will buy them off you

Regards Greg

I'll keep you in mind Greg.

[fb delivery]

it's funny I can remember this wagon sitting in a paddock west of Toowoomba some time back, not far from where I picked those bits up for you Trev................looking a lot better now

Yep, same paddock that had the white EK wagon with the Flash-line trim
{ i know as i tried to buy them, day late as aways }

Rob

[Trev]

it's funny I can remember this wagon sitting in a paddock west of Toowoomba some time back, not far from where I picked those bits up for you Trev................looking a lot better now

Maybe those parts belong back on the wagon? Destiny I'd say.

[Trev]

[EK283]

Looking good Trev

What primer are you using ?

Greg

[Trev]

2k from Spray Chief.

[Mick]

what's the windscreen trev

[Rusty EK]

Was thinking the same thing mick

[Trev]

That screen is one I chopped, I was a couple of inches off finishing and it cracked.
I'll use it as a template to get another one done.

[Blacky]

How did you chop it Trev ???? I need to do one for the Morry .....

[Trev]

It was one of Mez's, it was too big by about 1/2 inch so I used a flapper sanding disc and ground it down.
If it's a full size screen I will cut it first then finish with the flapper.

[Mick]

How did you chop it Trev ???? I need to do one for the Morry .....

is the morry split screen or one piece, i have an unbelievable story i know a guy that cut some front screens for a '51 chev old second hand glass but laminated with a 1 mill blade on a 4" grinder if you have some laminated glass may be worth a try