You'll be making tracks in no time
Keep it up
Slow EK rat.
-
Mick Jagger
- Posts: 3429
- Joined: Mon Dec 08, 2008 12:48 pm
- State: NOT ENTERED
- Location: Brisbane
Re: Slow EK rat.
kmawic
-
makntracks
- Posts: 36
- Joined: Fri Dec 19, 2014 11:56 am
- State: NT
- Location: Darwin, Australia
Re: Slow EK rat.
So i nearly have 1 side rust free..
Inner sill and outer sill and rear quarter done. A little annoyed that the replacement inner sill isnt dimpled as per the original..
Started sill on the other side.
Didn't find any money...
the inner silll is acuatlly not to bad on this side so i just replaced the bottom section.. saved a lot of work..
The floors have a few pin holes and are getting a bit thin. ill get away with the rear but ill replace the fronts.
Back to it then.
Cheers
Inner sill and outer sill and rear quarter done. A little annoyed that the replacement inner sill isnt dimpled as per the original..
Started sill on the other side.
Didn't find any money...
the inner silll is acuatlly not to bad on this side so i just replaced the bottom section.. saved a lot of work..
The floors have a few pin holes and are getting a bit thin. ill get away with the rear but ill replace the fronts.
Back to it then.
Cheers
-
parisian62
- Posts: 3996
- Joined: Wed May 11, 2005 2:19 pm
- State: NSW
- Location: Sydney
- Contact:
Re: Slow EK rat.
You're not mucking around! Great work 
Feelin free in a '61 FB.
Member of FB-EK Holden Car Club Of NSW Inc.
Check out the Rebuild of Old Timer
Member of FB-EK Holden Car Club Of NSW Inc.
Check out the Rebuild of Old Timer
-
makntracks
- Posts: 36
- Joined: Fri Dec 19, 2014 11:56 am
- State: NT
- Location: Darwin, Australia
Re: Slow EK rat.
My teethy grill coming along. with FB/EK overiders getting hard to find i had to broaden the search.. something a little different..
