Weber Carbies

[JOD34N]

Hi Mick,

The guy who made the manifold was Pete Mallaby (FCHOON) on the FEFC forum http://fefcholden.org.au/forum/index.ph ... file;u=125
Send him a PM, really helpful & does a relly neat job. Not sure on cost yet.

Fingers,

Finally got the car running OK, I used a 50 idle jet in the primary side & we put on a gas tester & found the main in the primary was way too lean, causing it to starve. Out with the jet drills & just made it bigger. the jet had 135 on it & we took it out to around 160. Still a little hesitation when going to secondaries, but nothing too bad. When I have the spare cash I might get it dyno-tuned.

Hope this helps,
Dean.

[fingers]

Hi Mick,

The guy who made the manifold was Pete Mallaby (FCHOON) on the FEFC forum http://fefcholden.org.au/forum/index.ph ... file;u=125
Send him a PM, really helpful & does a relly neat job. Not sure on cost yet.

Fingers,

Finally got the car running OK, I used a 50 idle jet in the primary side & we put on a gas tester & found the main in the primary was way too lean, causing it to starve. Out with the jet drills & just made it bigger. the jet had 135 on it & we took it out to around 160. Still a little hesitation when going to secondaries, but nothing too bad. When I have the spare cash I might get it dyno-tuned.

Hope this helps,
Dean.

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
Thanks Dean ...Any updates .....I got a six cyclinder jet kit from the states so when I get the manifold I should have the jets for the job ...thanks for your info mate ...much apreciated .....Fingers