Replacing front clip

[WesternWagon]

Just about ready to bolt the front clip back on the wagon.

Have a question? When I removed it there was some type of adhesive / sealant on the upper firewall section, is this required to prevent movement / rubbing? If so what is used?

It was similar to body deadener I have looked at the FB and it is the same.

Any advice very welcome.


Cheers

Gazza

http://i922.photobucket.com/albums/ad64 ... G_0990.jpg

[Bluehaze]

Sounds like the stuff you need is seam sealer. Used to seal the welded panel junctions and screwed/ bolted parts to prevent the ingress of moisture to areas where it can become trapped and cause rusting. You can get it either in a can or caulking tube.

[WesternWagon]

Cheers Bluehaze

I will go have a butchers in the moring

Cheers

Gazza