fbekholden.com

Hi has anyone got a drawing of the blow up of the EK parking light assembly. Is it just attached to the fender and grill?
Thanks for any help.
Regards Ceej

Thanks the 3/16 UNC looks right I will try and get them.

Hi can someone tell me the bolt size and thread for the removal and replacement of the near side park light fitting?

Brett has given me size so I will dig into my springs and see if I can find one.

Yes the lock came off coming back from the Nationals saved the complete lock but the spring dropped on to the road I might take the passenger side off to get a copy of the spring.

Does any one have or know trhe size of the spring in the front door quarter window lock?

Hi Blacky I would like to add my interest to buy 1 or 2 if you decide to make them I bought one from early Bitz which was in 3parts with what looked like a copper cotter pin going the spring into a brass bush it works but I have used a fair bit of conducting grease on the plate. Fingers crossed we c...

Thanks Greg it makes sense now. I will try to find a 2 pole hazardous flasher switch and fit a electronic flasher on it as the LED lights wont work with a normal flasher can. I am pretty sure I can now get it to work.
Thanks Again

Thanks Harv the best workshop instruction manual ever seen Hopefully we wont need it going to Toowoomba!

Thanks Harv best workshop manual advice blow by blow. Hope it is a steel one in there and we wont have a problem.

Fuel pump? If there is a fuel filter check that out first.

Where is the best place to buy the timing gears in steel or maybe alloy? Which is the best set to buy?

I fitted split LED's in the front parkers originally used resistors but could not get the flash down to a slow enough speed so bought the electronic flasher I had to then remove the resistors but leave the incandescent bulbs in the rear. They now work really well. I then added LED Halo headlights th...

If the breather is not there where can I get one to replace mine.? The manual does not really show it. Is it essential for the transmission to work properly?

Gordon is OK now , he really does know the Holden Hydramatic transmission probably better than any one else in Australia at the moment. I highly recommend him for any Hydramatic problem you may have.