fbekholden.com

Which coolant do people use for ek grey motor with hydramatic?
Cheers
Geoff

Hi,
My radiator overflow metal tube the one the rubber hose connects to has come loose and it's leaking coolant. How do I re-connect it to the radiator so it seals properly without leaking coolant everywhere? I tried Jb-weld on the outside but it still leaked, my radiator cap is only new 7lbs with ...

Hi,
I've finally replaced my non working interior light that wasn't wired up with a new one, now I don't know where the wires connect to, do I have to solder them on? Anyone have any pictures?
Many thanks
Geoff

Here's the picture of the really bent one. And yes its got a dent in it, its be best one I've got lol.

Thanks Rob,
Sounds like I need to take it off again, when I was putting it back together it looked like I had left and right overrides as the holes didn't line up on one side, but would fit on the over side. Appreciate your help. I'll post up a picture tomorrow Errol.
Regards
Geoff

Hi,
I recently picked up a second hand ek holden front bumper and overriders and used the right and center section and fitted the overriders onto the new bumper and they don't sit straight, they are leaning out. How can I straighten up the overriders or is this normal?
Thank you
Geoff

I'm looking for the round spring that's in the middle of the bonnet latch as mine is broken and its impossible to find one. My latch is undone by using the bonnet cable which is broken as well, my bonnets been moving up and down while driving for a while now. I don't want to have to buy a whole new ...

Anyone know any good/capable hydramatic transmission repair shops in Canberra that can service repair my leaking hydramatic. It seems to be leaking only after driving it. Once parked overnight, it leaves a nice big puddle on the garage floor. I've stopped the leaking cooling hose, fitted a new pan ...

Hi All,
I ended up just purchasing a braided flexible transmission hose on ebay from Early holden parts, very good product and worked. No one in Canberra was willing to make me up a new flexible hose. So I fitted my new metal cooling line and flexible hose with a new brass connector and finally its ...

oz_ek wrote:http://www.brakequip.com.au

Thanks for that I will give the ACT distributors a go.

Hi SunnyTim,
Unfortunately I'm in Canberra, no one seems to have the connectors down here.
Regards
Geoff

Sorry yes a hydramatic.

Hi,
Anyone know where I can get a replacement braided flexible transmission hose that goes from the radiator to the metal cooling lines? I've tried everywhere in Canberra (Enzed, pirtek, brake shops etc and no-one has the parts to make one up. I can get 2 on ebay for $200 but the seller is away till ...

Ok I fitted new cooling line for the hydramatic and now it's leaking worse than it was before, is there a trick to installing the cooling lines so they seal properly, as its tightened but I don't want to over tight it.
Thanks
Geoff

Thanks Trev, I like your idea sound good to me, what length bolts did you have to use. I've already got the plates.
regards
Geoff