fbekholden.com

Hi Clay,

In regard to your original post, were Vehicle Standards Ok with the mix of duo-servo brakes on the front and the original semi-huck at the rear?

Is there any concerns with the different operating arrangements of the duo-servo and semi-huck?

Cheers
Frank

Thank you both bigtime.

I'll contact them to discuss.

Regards

Frank

Hi all,

I have reached the point where it's time to do a re-upholster of my project.

Would anyone have a recommendation for an auto trimmer that is familiar with old Holdens and is in the Melbourne area ?

Thanks in advance.

[emoji846]

Sent from my SM-S9060 using Tapatalk

Hi all,
I'm looking for an FE/FC/FB/EK Holden clutch slave cylinder, part number 7409952, casting number 7409134.
I'll be reconditioning it so it doesn't need to be in working condition.
Thanks.

Sent from my SM-S9060 using Tapatalk

Hi all,

I'm at the electrics stage of my rebuild and wondering if anyone would recommend an auto electrician that could check/recondition my generator, starter and regulator?

Preferably Melbourne area so I don't have to post.

thanks in advance

Hi Fingers,
How will you set up the choke?
Cheers

Hi all,

I need a left rear brake backing plate if anyone has one for sale. I need it to be in Ok condition, mine is warped.

I'm in Melbourne south east suburbs but happy to go for a drive (subject to lock downs) to pick it up or to pay postage.

Thank you

Hi Rob,

It's for an FC. Though I thought FE FC FB EK were interchangeable. May be wrong.

Hi all,

I'm after a front or rear bumper bar middle section in good condition. I'll buy the whole bar too.
I live in Melbourne eastern suburbs but not looking to pay freight so local-ish preferred.

Thanks

Hi,

I'm after a set of FB EK front brake drums like the finned type in the picture below. I'll also take the whole brake assembly - backing plate etc - if it's complete and I can afford it.

I'm in Melbourne south east suburbs and would like to pick up but happy(ish) to pay postage too.

http ...